Sony DCR-SR220 - Manual (Page 35)

Recording/Playback
35
Playing the image on a TV
Connect your camcorder to the input jack of a TV or VCR using the A/V connecting cable
 or an A/V connecting cable with S VIDEO . Connect your camcorder to the wall
outlet (wall socket) using the supplied AC Adaptor for this operation (p. 13). Refer also to the
instruction manuals supplied with the devices to be connected.
 A/V connecting cable (supplied)
The Handycam Station has an A/V
OUT jack (p. 102) and the camcorder
has an A/V Remote Connector (p. 99).
Connect the A/V connecting cable
either to the Handycam Station or to
your camcorder, according to your
setup.
 A/V connecting cable with S VIDEO
(optional)
When connecting to another device
via the S VIDEO jack, by using an A/V
connecting cable with an S VIDEO
cable (optional), higher quality images
can be produced than with an A/V
connecting cable. Connect the white
and red plugs (left/right audio) and
the S VIDEO plug (S VIDEO channel)
of the A/V connecting cable with an
S VIDEO cable (optional). The yellow
plug connection is not necessary.
Connecting only the S VIDEO plug will
not output audio.
Notes

Do not connect A/V connecting cables to both
your camcorder and the Handycam Station at
the same time. The image might get disturbed.
Tips

You can display the counter on the TV screen
by setting [DISP OUTPUT] to [V-OUT/
PANEL] (p. 67).
When your TV is connected to a VCR
Connect your camcorder to the LINE IN
input on the VCR. Set the input selector
on the VCR to LINE (VIDEO 1, VIDEO 2,
etc.), if the VCR has an input selector.


A/V OUT jack
Device without
an S VIDEO jack
: Signal flow
VCRs or TVs
Device with an
S VIDEO jack
(Yellow)
(White)
(Red) (Yellow)
(White)
(Red)