Alamo SHD88 - Manual (Page 134)

MAINTENANCE
SHD 03/09 Maintenance Section 5-8
© 2009 Alamo Group Inc.
MAINTENANCE
Inboard (Drive) Bearing- Images Mnt-FL-0023 and Mnt-FL-0020.
7. Remove belt guard.
8. Remove spring from idler arm.
9. Remove extension shaft housing mounting bracket fasteners at the cutterhousing. Pivot mounting bracket
assembly and remove drive belt.
10. Remove fasteners that secure pulley to cuttershaft. Remove pulley and key.
11. Remove fasteners securing inboard bearing and housing assembly to cutterhousing; then, remove bearing
and housing assembly.
NOTE: There are two tapped holes in the housing which can be used to pull bearing and housing assembly out
by using special tool No. 701627.
12. Using a jack to align parts, install inboard bearing and housing assembly to cutter unit. Grease bearing and
install cap over fitting.
13. Reinstall key and pulley. Secure with cuttershaft fasteners.
14. Remove jack and check shaft rotation. Reinstall knives which were removed.
15. Reinstall drive belts then secure motor mounting bracket to cutterhousing.
16. Reinstall idler arm spring.
17. Reinstall belt guard
18. Remove supports, lower unit to ground and test unit. Reinstall outboard fender, if not already installed.