Ultra Start CJ Series - Manual (Page 5)

Transmitter Programming
Follow the steps below to program the transmitters to the system s memory
Step 1 - Turn the Ignition key ON then OFF - Leaving Key Off.
Step 2 - Press and release the Program Button twice then press and hold.
Step 3 - The siren will respond with five chirps to confirm Transmitter Program Mode.
Note: If the siren does not respond, repeat Steps1&2
Step 4 - Continue to hold the Program Button and press lock button on each of the
transmitter’s to be programmed(Maximum of 3 Different transmitter codes).
Step 5 - The system will respond with a siren chirp each time a transmitter is programmed.
Exit - After five seconds the system will exit transmitter program mode automatically.
NOTE: You must program ALL of the transmitters to be used at one time. For the owner’s
security any transmitters not programmed at this time will be erased from memory.
*** This system will store a maximum of three transmitter codes in memory.
REMOTE VEHICLE SECURITY
OWNER’S MANUAL
PAGE 5
Carefully remove
the screw from the
back of the remote.
Remove the top
case, then replace
the battery.
Replace top case
and Re-install
screw.
Test remote for
proper operation.
Battery Replacement
The transmitter battery should be changed at least once every year to maintain
proper operating range. Replace with a quality 23A 12volt Alkaline battery
(OE remote). Replace with two quality 3V lithium batteries (XR remote).