AT&T ISSUE 3 - Manual (Page 2)

AT&T
2.
3.
4.
1.
2.
Plug one end of the coiled handset cord
into the jack in the handset. Push the
plug in until it clicks. INTRODUCTION
JACK
OPENING
RINGER
VOLUME
CONTROL
This booklet contains installation and
removal instructions for standard modular
desk or wall telephones.
Plug the other end of the cord into the
jack in the bottom of the wall base.
Push the plug in until it clicks.
Jack For Wall Telephone
Figure 1. Standard Modular Telephone
Jacks
If you do not have a standard modular
telephone jack, contact your local
telephone company or AT&T Information
Systems for details on converting your
present outlet to a modular jack.
INSTALLATION
Your telephone is fully assembled except
for the coiled handset cord and clear line
cord.
To Install Your Desk Or Trimline®
Telephone
Installation of the following options requires
a professional installer.
Adjunct Dialer
Adjust the ringer volume switch on the
upper right side of the telephone to the
desired setting.
SPOKESMAN® Loudspeaker
For All Telephones External Speakerphone
Place the number card on your telephone
following the instructions on the back of
the number card label. Headset Adapter
Contact your place of purchase for details.
Package Content HANDSET
Make sure your package contains the
following items:
RINGER
VOLUME
CONTROL
BASE
●
●
●
●
●
●
●
●
●
RINGER
VOLUME
CONTROL
Telephone
Handset
RIVETS
JACK
COILED HANDSET
CORD JACK
WALL
PHONE
PLUG
COILED
HANDSET
CORD
HANDSET
Handset cord
Line cord Plug one end of the coiled handset cord
into the opening in the handset. Push
the plug in until it clicks. (Figure 2)
Plug the other end of the cord into the
side opening in the base. Push the plug
in until it clicks.
Plug one end of the clear line cord into
1.
2.
3.
Number card
Modular Outlet Requirement
You must have a standard modular
telephone jack, such as one of those
shown below, to install your phone. If you
have one of these jacks already mounted,
no tools are needed.
COILED HANDSET CORD
the jack in the base of the telephone.
Push the plug in until it clicks. Figure 3. Setting the Ringer Volume
Control (Desk and Trimline Telephones)
Plug the other end of the cord into the
JACK
telephone jack in your office. Push the
JACK
CLEAR
LINE
CORD
OR
JACK
JACK
HANDSET
COILED
HANDSET
CORD
plug in until it clicks.
Turn your telephone over or for Trimline
telephones, lift the handset. (Figure 3)
Set the ringer volume switch or
Figure 4. Wall Telephone Installation
4.
5.
6.
1.
To Remove Your Telephone
thumbwheel to the setting you want.
To Install Your Wall Telephone
Align the wall phone plug with the jack,
then line up the hole in the back of the
telephone set with the rivets on the wall
outlet plate. Push in and slide the
telephone down into place. (Figure 4)
JACK OPENING
JACK OPENING
To disconnect or remove your telephone
reverse the installation procedures. To
remove any modular plug, squeeze the
clip of the plug and pull it out of the
jack.
To disconnect a wall set, slide the set up
to lift it off the rivets and pull it away
from the wall.
Jacks for Desk or Trimline® Telephones Figure 2. Desk Telephone Installation