Konica Minolta bizhub C650 - Manual (Page 270)

C650 8-2
Appendix 8
8 Appendix
8.1 Error message list
If any of the following error messages appear, perform the operations described below.
2
Note
For details on the network settings, refer to the User’s Guide [Network Scanner Operations].
Message Cause and remedy
Cannot connect to the net-
work. A connection to the network could not be established. Check if the network cable is
correctly connected. In addition, check that the Network Setting parameters on the
Administrator mode have been correctly specified.
The destination cannot be se-
lected because the number of
destinations has exceeded the
max. number of broadcasting
possible. The number of destinations specified exceeds the number possible for a broadcast
transmission. Reduce the number of broadcast destinations, or send the transmis-
sion in multiple batches.
Image could not be saved in
the User Box due to insuffi-
cient HDD capacity check log. The hard disk is full. Delete unnecessary data, and then try saving the data again.
The number of User Boxes
has reached its maximum. The number of user boxes that can be registered has reached the maximum number
possible. Delete unnecessary user boxes, and then try registering new boxes again.
This user box has reached its
maximum number of docu-
ments allowed. The number of documents that can be saved in a user box has reached the maximum
number possible. Delete unnecessary documents, and then try saving the document
again.
The number of programmed
jobs has reached the max. al-
lowance.
Wait until a programmed job is
completed. The number of jobs that can be programmed has reached the maximum number
possible. Wait until a job has been completed, or delete a current job.