Konica Minolta bizhub C3350 - Manual (Page 49)

5-14 [Quick Start Guide]
Using the fax function 5 5.3
Basic
Us
age
Chap
te
r 5
5
Press the Start key.
% Tap [Check Settings] before sending data, and check the specified destination and settings if nec-
essary.
% To redo operations for specifying destinations or option settings, press the Reset key.
% If you press the Stop key while scanning the original, scanning stops. To cancel scanning the orig-
inal, delete inactive jobs from the Job screen.
Sending starts.
5.3.3 Introduction of fax transmission function
This section describes convenient fax transmission functions. For details on how to use each function, refer
to Chapter 4 "Sending Options" in [User's Guide: Fax Functions].
Function Overview
Timer TX Timer TX automatically starts sending at a specified time if the time is pre-
specified.
Check Dest. & Send Check Dest. & Send checks the fax number specified for the fax transmission
against the destination fax number (CSI) and sends the fax only when they
match.
F-Code TX F-Code TX specifies the F code (SUB address and sending ID) to send a fax.
Confidential communication and relay distribution request are available.
•
The confidential communication function is designed to communicate with
specific people using a Confidential RX User Box that requires a registered
number and a password.
• Relay distribution request is a function that the relay station, which has re-
ceived a fax, distributes the received fax to a pre-registered group.
Quick Memory TX Fax transmission starts concurrently with scanning one page. The total num-
ber of pages transmitted can be entered in the sender record.
Password TX Password TX sends a fax with a password. It is used to send faxes to a device
on which fax peers are restricted by passwords (a device with Closed Network
RX enabled).
Polling TX Polling TX stores a file beforehand on the internal hard disk and sends it out
upon a request for reception (polling request) from the recipient.