Konica Minolta bizhub C353P - Manual (Page 56)

C353P 2-41
Administrator Operations 2
2.10 SNMP Setting Function
When access to the Administrator of the machine by the System Settings is authenticated, the machine
enables changing of the SNMP v3 Write User Password (auth-password, priv-password) required for
accessing the MIB object over the network using the SNMP from the PC. In PageScope Web Connection,
import/export of the Device Setting is enabled, allowing the setting for Security Level of SNMP v3 Setting to
be saved or the saved backup data to be restored.
Each of the auth-password and priv-password can consist of 8 to 32 digits. The password entered for the
authentication purpose appears as "*" or "
●" on the display.
2.10.1 Changing the auth-password and priv-password
2
Note
Do not leave the machine with the setting screen of System Settings left shown on the display. If it is
absolutely necessary to leave the machine, be sure first to log off from the System Settings.
<From the Control Panel>
1
Press the [Menu/Select] key.
2
Press the [,] key to select [System Settings].
3
Press the [Menu/Select] or [)] key.
4
Press the [+] and/or [,] key to enter the 8-digit Administrator Password.
– Press the [*] key to delete the last character entered.
5
Press the [Menu/Select] key.
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password is entered, a message appears saying that there is a mismatch
in the Administrator Passwords and entry of the Administrator Password will be prohibited for five
sec. Wait for some while before entering the correct Administrator Password.
% If the EnhancedSecurity is set to [ON], entry of a wrong password is counted as unauthorized ac-
cess. If a wrong Administrator Password is entered a predetermined number of times (once to three
times) set by the Administrator of the machine or more, a message appears saying that the machine
accepts no more Administrator Passwords because of unauthorized access for any subsequent en-
try of the Administrator Password. The machine is then set into an access lock state. To cancel the
access lock state, settings must be made by the Service Engineer; or, turn off, and then turn on, the
main power switch of the machine. If the main power switch is turned off and on, the access lock
state is canceled after the lapse of time set for [Release Time]. When the main power switch is
turned off, then on again, wait at least 10 seconds to turn it on after turning it off. If there is no wait
period between turning the main power switch off, then on again, the machine may not function
properly.