Konica Minolta magicolor plus - Manual (Page 16)

E-16
Operation Steps
When used as a Captureboard
The Captureboard uses a CCD image sensor to read the text and drawings that have been written down with
dedicated (4-color) markers, and accumulates the image data in internal memory.
The "TOOLBOX" software on the included CD-ROM can be used to combine the image of the projector project-
ed onto the sheet surface with the words or diagrams drawn on the sheet surface.
Preparation
• Set up the newly purchased Captureboard and connect a printer.
See a separate manual titled “Assembly and Setup Manual.”
• Plug the AC power plugs of the captureboard and printer into wall power outlets. See page E-13.
• Set the time of the newly purchased Captureboard. See Page E-14.
Write and Draw on the Sheet Surface
Please use the supplied dedicated markers for drawing. To erase something, erase it with the sup-
plied dedicated eraser.
Please be sure to use the dedicated markers and erasers. Using other markers or erasers may
result in the markings not coming off, or may stain the sheet.
When Not Using the Captureboard
(1) By all means, cleanly erase the drawing from the sheet surface with the dedicated eraser. (Leaving the drawing for a
long period will make it harder to erase.)
(2) When disconnecting the USB cable of the Captureboard and personal computer, first disconnect the USB at the per-
sonal computer side.
(3) Press the ON/Standby button of the Captureboard and switch off the power (standby mode).
When combining the sheet surface draw-
ing with a projector image
(1) Connect the computer on which "PLUS TOOLBOX"
is installed to the captureboard.
(2) Project the image of the personal computer with
the projector.
(3) Adjust the projected image for a suitable size.
(4) Use the supplied dedicated marker to draw a circle
“o” at the four corners of the projection image.
(5) The image of the sheet screen will be read. Check
that there is a combined image on the computer
screen.
(6) Save the combined image on the personal
computer.
Note
• For details on operating PLUS TOOLBOX and on
connecting devices, refer to the separate " Software
Operation Manual".