Konica Minolta eCopy - Manual (Page 10)

6 | Installing and configuring the connector
Installation prerequisites
The following are the installation prerequisites:
■
Interwoven WorkSite version 8.0, 8.1, or 8.2
■
eCopy ShareScan OP 4.0 Service Pack 2 or later
Installing the eCopy Connector for Interwoven WorkSite
To install the eCopy Connector for Interwoven WorkSite:
1
Insert the installation CD. If the installer does not start automatically, double-click
Launch.exe on the CD.
2
Click Install Connector to start the installation.
3
Follow the on-screen instructions
4
When the installation is complete, click Finish.
Note: eCopy recommends that you do not install the WorkSite server or the DeskSite client on the same
computer as the ShareScan OP server.
Important! Before installing the connector, make sure that the ShareScan OP software is installed and
functioning correctly. Refer to the eCopy ShareScan OP Installation and Setup Guide for details.