Konica Minolta bizhub C10 - Manual (Page 38)

Basic Fax Operation 32
Sending a Fax Using the Original Glass
1
Press the Fax key to enter Fax mode.
2
Remove all documents from the ADF.
"
If you are using the original glass to scan, do not load any documents
into the ADF.
3
Lift to open the ADF cover.
4
Place the original document face down on the original glass and align the
document on the scales above and to the left of the original glass.
5
Gently close the ADF cover.
"
Closing it too quickly may cause the document to move on the original
glass.
6
Press the Resolution key to specify the desired image quality.
"
The document image quality can be adjusted by pressing the Resolu-
tion key. For details, refer to “Improving Resolution” on page 34.
7
Specify the fax number of the recipient in one of the following ways:
– Direct dialing
– Using the one-touch dial keys (including group dialing)
– Using the speed dial numbers
– Using the phone book functions
– Using the Redial/Pause key
"
For details on specifying the recipient, refer to “Specifying a Recipient”
on page 34. For details on using the Redial/Pause key, refer to “Using
the Redial Function” on page 38.
"
A transmission can also be sent to multiple recipients with the Broad-
cast function. For details on sending a broadcast transmission, refer to
“Sending a Fax to Multiple Recipients (Broadcast Transmission)” on
page 38.
8
Press the Start key.
A screen appears, requesting confirmation of the scanning area.
9
To scan the displayed scanning area, press the Menu Select key. The
document is scanned.
"
To change the displayed scanning area, press the , key, select the
desired scanning area in the next screen that appears, and then press
the Menu Select key. Press the Menu Select key again to start scan-
ning.