Konica Minolta bizhub C20PX - Manual (Page 129)

Network Connection 111
Setting the Address Manually
You may also manually change the printer’s IP address, subnet mask, and
gateway by using the following instructions. (See chapter 6, “Understanding
the Ethernet Configuration Menus,” for more information.)
"
When manually setting the IP address, turn off DHCP, BOOTP and
ARP/PING first. In addition, when the IP address is changed, add a
new port or reinstall the printer driver.
CAUTION
You should always notify your network’s administrator before changing
the printer’s IP address.
1
Turn on your PC and printer.
2
When the printer’s message window displays READY , set the IP address.
Press this
key . . . (until) the message window reads . . .
READY
PROOF/PRINT MENU
or if no optional hard disk kit is installed:
PRINT MENU
INTERFACE MENU
JOB TIMEOUT
ETHERNET
TCP/IP