Konica Minolta bizhub C35 - Manual (Page 130)

Error messages 8-9
Error messages
If a machine malfunction occurs, the error screen appears with one of the fol-
lowing error messages. Refer to the following table, and then perform the
indicated operation.
If fax transmissions/receptions still cannot be performed correctly, even after
performing the described operations, contact your technical representative.
Error message Cause Solution
[Off-Hook] The machine has been
left off-hook after a man-
ual transmission. Put the machine back
on-hook.
[Memory Full (Fax)] The memory is full. If a fax is being sent,
send the scanned docu-
ment pages. Otherwise,
send the fax manually.
If a fax is being received,
print the received docu-
ments saved in the
memory.
[Fax TX Failed] An error occurred while
a G3 fax is being sent. This error is automati-
cally cleared.
[Fax RX Failed] An error occurred while
a G3 fax is being
received. This error is automati-
cally cleared.
[PC-Fax TX Error] An error occurred while
receiving PC-Fax TX
data. This error is automati-
cally cleared.
[Polling RX Error] Multiple destinations
were specified for polling
reception. Multiple destinations
cannot be specified for
polling reception. Try
performing the opera-
tion again with only one
destination specified.
[PC-Fax Restricted] A PC fax transmission
was requested although
PC fax transmissions
are prohibited. For details on specifying
PC fax transmission set-
tings, refer to “[Fax
Function Settings]” on
page 2-13.
[I-Fax TX failed] An error occurred while
an Internet fax is being
sent. This error is automati-
cally cleared.