Konica Minolta bizhub C35 - Manual (Page 57)

Specifying scan settings 3-12
Procedure
1
Press [Fax] or press the [Fax] key to display the initial Fax screen.
2
Place the document in the ADF or on the original glass.
3
Specify the destination.
4
Press [Settings].
5
Press [Scan Settings].
6
Set [Separate Scan] to [ON].
7
Press the [Start] key.
The document is scanned.
8
Load the next batch of document pages, and then press the [Start] key.
– Repeat this operation until all document pages have been scanned.
– Press [Change Settings] to change the scan settings.
9
After all pages of the document have been scanned, press [Finish].
[Density]
Select the density at which the document is to be scanned.
Nine density levels are available. Select the appropriate density setting
according to your document.
[Background Removal]
Select the density of the background color at which documents with a back-
ground color are to be scanned.
Nine density levels are available for the background color.
[Sharpness]
Select the strength of outlines, for example, on characters and lines, for scan-
ning the document.
To scan characters and lines with greater sharpness, select a setting toward
“+”. Seven sharpness levels are available.