Konica Minolta bizhub C35 - Manual (Page 58)

Specifying communication settings (G3 fax) 3-13
Specifying communication settings (G3 fax)
With [Line Settings] in the [Comm. Settings] screen, settings for the transmis-
sion line can be specified.
[ECM OFF]
The error correction mode (ECM) is turned off when data is being sent.
ECM is an error correction mode defined by ITU-T (International Telecommu-
nication Union - Telecommunication Standardization Sector). Fax machines
equipped with the ECM feature communicate with each other while confirm-
ing that the sent data is free of errors. Therefore, communication can be free
of disturbances caused by telephone line noise, etc. If noise frequently
occurs, it may take a slightly longer time to complete a communication, com-
pared with when ECM is turned off. After the transmission has been com-
pleted, this machine automatically turns on ECM.
"
This setting cannot be used together with polling reception.
"
If [V34 OFF] is set to [No], [ECM OFF] cannot be set to [Yes].
[V34 OFF]
V.34 is a communication mode used with super G3 fax communication. When
the remote machine or this machine is connected to a telephone line through
a PBX, it may not be possible to establish communication in super G3 mode
due to the condition of the telephone line. In this case, it is recommended that
V.34 be turned off before sending data. After the transmission has been com-
pleted, this machine automatically turns on the V.34 mode.
"
This setting cannot be used together with polling reception.
[Check Dest. & Send]
The specified fax number is compared with the remote fax number (CSI), and
the data is sent only if the fax numbers match. If they do not match, the com-
munication will fail, resulting in a transmission error.
"
In order to use this function, the recipient’s fax number must be speci-
fied on their fax machine.