Konica Minolta bizhub C35 - Manual (Page 82)

Printing received faxes 4-13
When [Min. Reduction for RX Print] is set to [100%]
„ The pages cannot be split.
„ The image is not reduced.
„ [Tray Selection for RX Print] is set to [Auto].
„ Received documents are printed at full size on paper that fits the length of
the received image minus 20 mm. As a result, up to 20 mm of the trailing
edge of the image may be cut off. If the length of the received image is
more than 20 mm longer than the paper size, the image is printed on the
next larger paper size (most suitable paper size).
When [Print Separate Fax Pages] is set to [OFF]
„ The received document is automatically reduced (between 75% and 96%)
and printed. If the received document still does not fit within a single page,
even after being reduced up to 75%, any part of the image that does not fit
within the paper will be lost.
„ The image is reduced in both the main scanning direction and the
sub-scanning direction while maintaining the original height-to-width ratio.
„ If the orientation of the paper to be printed on is different from the orienta-
tion of the paper that was automatically selected, the image will not be
automatically rotated 90°.
When [Print Separate Fax Pages] is set to [ON]
„ The received document is reduced by the specified reduction ratio
(between 87% and 96%). If the document does not fit within a single
page, the document is split and the remainder is printed on the next page.
„ There is no overlapping section on split pages.
"
Pages are not split when the following settings have been specified,
even if [Print Separate Fax Pages] is set to [ON].
·When [Tray Selection for RX Print] is set to a specific drawer for print-
ing
·When [Min. Reduction for RX Print] is set to [100%]
·When [Paper Priority] is set to [Fixed Size] or [Size Priority]
·When [Duplex Print] is set to [ON]