Konica Minolta bizhub C35 - Manual (Page 130)

Print Media 4-5
"
Keep media between 15% and 85% relative humidity. Toner does
not adhere well to moist or wet media.
„ Layered
„ Adhesive
„ Folded, creased, curled, embossed, warped, or wrinkled
„ Perforated, three-hole punched, or torn
„ Too slick, too coarse, or too textured
„ Different in texture (roughness) on the front and back
„ Too thin or too thick
„ Stuck together with static electricity
„ Composed of foil or gilt; too luminous
„ Heat sensitive or cannot withstand the fusing temperature (180°C
[356°F])
„ Irregularly shaped (not rectangular or not cut at right angles)
„ Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
„ Acidic
„ Any other media that is not approved
Thick Stock
Paper thicker than 90 g/m 2 (24 lb bond) is referred to as thick stock.
You can print continuously with thick stock. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Capacity Tray 1/2 Up to 20 sheets, depending on their thick-
ness
Tray 3/4 Not supported
Orientation Tray 1 Face down
Tray 2 Face up
Driver
Media Type Thick 1 (91–150 g/m²)
Thick 2 (151–210 g/m²)
Weight 91 to 210 g/m²
Duplexing Refer to “Specifications” on page 4-2.