Konica Minolta bizhub C35 - Manual (Page 311)

Clearing Media Misfeeds 13-6
Clearing Media Misfeeds
To avoid damage, always remove misfed media gently, without tearing it. Any
piece of media left in the machine, whether large or small, can obstruct the
media path and cause further misfeeds. Do not reload media that has misfed.
Note
The image is not fixed on the media before the fusing process. If you
touch the printed surface, the toner may stick to your hands, so be
careful not to touch the printed face when removing the misfed media.
Make sure not to spill any toner inside the machine.
CAUTION
Unfused toner can dirty your hands, clothes, or anything else it gets on.
If you accidentally get toner on your clothes, lightly dust them off as
best as you can. If some toner remains on your clothes, use cool, not
hot water, to rinse the toner off. If toner gets on your skin, wash it off
with cool water and a mild soap.
CAUTION
If you get toner in your eyes, wash it out immediately with cool water
and consult a doctor.
If, after clearing the media misfeed, the misfeed message in the control panel
window persists, open and close the engine cover. This should clear the mis-
feed message.
Media misfeed indications
If a misfeed occurs during printing, the message “Misfeed detected” appears
and the location of the misfeed is indicated in the screen.
Media misfeed locations Page
reference
Media misfeed in Tray 2 page 13-7
Media misfeed in Tray 3/Tray 4 page 13-11
Media misfeed in the ADF page 13-13
Media misfeed in the duplex unit page 13-15
Media misfeed in the fuser unit page 13-16
Media misfeed in Tray 1 (manual feed tray) page 13-20