Konica Minolta bizhub C35 - Manual (Page 346)

Status, error and service messages 13-41
Operator messages
[The USB device is
invalid.]
[Disconnect USB device.]
An incompatible USB
device is connected to
the USB HOST port. Disconnect the USB
device from the USB
HOST port.
[IEEE802.1x Auth. failed]
[Please reboot.]
IEEE 802.1X port
authentication timed
out. Turn the machine off,
then on again.
[IEEE802.1x
Authenticating]
[Please wait.]
IEEE 802.1X port
authentication is being
performed. If authentication is suc-
cessful, the message is
cleared.
If authentication times
out, turn the machine
off, then on again.
Message Cause Solution
[Configuration of Options
Changed]
[Configuration of Options
Changed]
[Power Off and ON.]
An optional lower
feeder unit was
installed or removed
while the machine is
on. Turn the machine off,
wait a few seconds, and
then it on again.
[Cover Open]
[Cover is open.]
[Close all covers properly.]
The cover is open. Close the indicated
cover.
[Misfeed Detected]
[Misfeed was detected.]
[Remove the paper.]
A media misfeed
occurred. Open the indicated
cover, and remove the
misfed media.
[Imaging Unit Missing]
[Install imaging unit and
close all doors.]
No imaging unit is
installed. Otherwise,
an imaging unit
incompatible with the
machine has been
installed. Install the correct imag-
ing unit.
Message Cause Solution