1 accessing the admin. setting mode, Administrator operations, Accessing the admin. setting mode -2 – Konica Minolta bizhub C450P User Manual

Page 19: 2administrator operations

Advertising
background image

2

Administrator Operations

2-2

C450P

Ad

minist

ra

to

r Op

er

at

ions

Chapter 2

2

Administrator Operations

2.1

Accessing the Admin. Setting Mode

This machine implements authentication of the user of the Admin. Setting
mode function through the 8-digit Administrator Password that verifies the
identity as the Administrator of the person who accesses the function. During
the authentication procedure, the Administrator Password entered for the
authentication purpose appears as “*” or “

●” on the display.

When the EnhancedSecurity mode is set to “ON,” the number of times in
which authentication fails is counted.

2.1.1

Accessing the Admin. Setting mode

The machine does not accept access to the Admin. Setting mode under any
of the following conditions. Wait for some while before attempting to gain ac-
cess to the Admin. Setting mode again.
-

The Admin. Setting mode has been logged on to through access made
from the PC.

-

A remote operation is being performed from an application on the PC.

-

There is a job being executed by the machine.

-

Immediately after the main power switch has been turned ON.

-

A malfunction code is displayed on the machine.

2

Note

Make sure that none of the general users of the machine will know the
Administrator Password.

If the Administrator Password is forgotten, it must be set again by the
Service Engineer. Contact your Service Representative.

Do not leave the machine with the Admin. Setting mode setting screen
left shown on the display. If it is absolutely necessary to leave the ma-
chine, be sure first to log off from the Admin. Setting mode.

While you are logging onto the Admin. Setting mode using PageScope
Web Connection, any operations from the machine’s control panel are
disabled.

If another Administrator has already accessed the Admin. Setting mode
using the PageScope Web Connection, the machine displays a message
that tells that a remote operation is being performed and rejects any op-
eration on the control panel. Wait until the message disappears before at-
tempting to access the Admin. Setting mode once again.

c450P_security_E.book 2 ページ 2007年4月10日 火曜日 午後6時49分

Advertising