Xerox WorkCentre C2424-5984 - Manual (Page 4)

Connections and Internet Protocol (TCP/IP)
WorkCentre® C2424 Copier-Printer
6-4
Connecting via USB
A USB connection requires a standard A/B USB cable. This cable is not included with your
system and must be purchased separately. Verify that you are using the correct USB cable for
your connection.
Windows 98 or Later and Windows 2000 or Later
1. Connect the USB cable to the system and turn it On.
2. Connect the USB cable to the PC and follow the Add New Hardware Wizard to create
the USB port.
3. Follow the Add Printer Wizard to install the driver from the WorkCentre C2424 Software
CD-ROM.
For more information, go to the table of infoSMART Knowledge Base documents at the end of
this section.
Macintosh OS 9.x
A USB-connected system does not display in the Chooser.
1. Install the driver from the WorkCentre C2424 Software CD-ROM.
2. Use the Desktop Printer Utility to create a desktop USB system. The utility is located in
the PhaserTools folder which is created during the software installation.
For more information, go to the table of infoSMART Knowledge Base documents at the end of
this section.
Macintosh OS X (10.1 and Higher)
1. Install the driver from the WorkCentre C2424 Software CD-ROM.
2. Open the Print Center utility. In Macintosh OS X, version 10.3 or higher, the utility is
called Printer Setup. To locate utilities on the Macintosh hard drive, open the
Applications folder, then open the Utilities folder.
3. Click the Add button.
4. Select USB from the top drop-down list.
5. Select the system in the printers window.
6. Verify that your system is set to Auto Select.
7. Click the Add button.
The system is displayed as an available printer in the Print Center/Printer Setup. For more
information, go to the table of
infoSMART Knowledge Base documents at the end of this
section.