Olympus FE-240 - Manual (Page 27)

Me
nu operati
o
ns
EN
27
The pixel mapping feature allows the camera to check and adjust the CCD and
image processing functions. It is not necessary to operate this function
frequently. Approximately once a year is recommended. Wait at least one minute
after taking or viewing pictures to allow the pixel mapping function to perform
properly. If you turn the camera off during pixel mapping, start again.
Select [PIXEL MAPPING]. When [START] is displayed, press
.
This function is used to turn on the camera when K or q is pressed.
• Press ON to adjust the volume.
• You can adjust the volume to one of five levels or mute
the volume.
PIXEL MAPPING
..............................Adjusting the image processing function
K/ q
...................................... Turning on the camera with the K or q button
YES/ NO
s
......................................................................Adjusting the monitor brightness
BRIGHT/ NORMAL
BEEP
.................................................... Adjusting the volume of operation sound
when the buttons are pressed
OFF (No sound)/ LOW /HIGH
8
............................................... Adjusting the volume of camera warning sound
OFF (No sound)/ LOW / HIGH
SHUTTER SOUND ........................Adjusting the volume of the shutter button
OFF (No sound)/ LOW / HIGH
VOLUME
.................................................. Adjusting the volume during playback
OK MENU
2
1
3
SETUP
BEEP
SHUTTER SOUND
VOLUME
SET BACK