Brother NC6100H - Manual (Page 129)

A - 2 APPENDIX
HTTP (Recommended)
Use your favorite web browser to connect to the Brother print server.
This will allow you to configure printer and/or print server parameters.
WebJetAdmin
Brother's print server range is HP WebJetAdmin compatible.
TELNET
To connect to the print server using TELNET on UNIX, Windows
NT
® 4.0, or most other TCP/IP systems, type: TELNET ipaddress
at the command prompt of the system prompt, where ipaddress is
the IP address of the print server. When you are connected, click
RETURN or ENTER to get the "#" prompt, enter the password
access (the password will not appear on the screen), and type
anything in response to the Enter Username > prompt. When you
see the Local > prompt, you are ready to enter commands.
Enter HELP at the command prompt for a list of supported
commands.
BRCONFIG
The Brother BRCONFIG utility runs from the DOS system prompt
and is installed with BRAdmin. To connect the print server using the
Brother BRCONFIG NetWare utility, choose the BRCONFIG utility
from the Brother BRAdmin utilities menu. If you have only one print
server, you will be immediately connected to that server. If you have
more than one print server, you will be given a list of available print
servers. Type the number of the print server to which you wish to
connect. When you are connected, enter the password
access (the
password will not appear on the screen) at the "#" prompt, and type
anything in response to the
Enter Username > prompt. When you
get the Local > prompt, you are ready to enter commands. To use
BRCONFIG, a Novell Server (running the IPX protocol) is necessary
and an active connection must be made to the server.
Enter HELP at the command prompt for a list of supported
commands.