Brother NC6100H - Manual (Page 76)

NOVELL NETWARE PRINTING 6 - 14
Configuring the Brother Print Server (Queue
Server Mode in Bindery Emulation Mode) Using
PCONSOLE and BRCONFIG
1 Login as Supervisor (NetWare 3.xx) or ADMIN (NetWare
4.1x or later; be sure to specify the /b option for bindery mode).
2 Execute BRCONFIG from the Windows ® menu.
3 Select the corresponding server name from the list of print
servers.
4 When you get the message that the print server is connected,
type the default password
access in response to the # prompt
(the password will not echo), and then press the ENTER key in
response to the
Enter Username> prompt.
5 When you get the Local> prompt, type:
6 SET NETWARE SERVER servername ENABLE
Where servername is the name of the file server on which the
print queue will reside. If there is more than one file server that
you wish to print from, repeat this command as many times as
necessary.
7 Type EXIT to exit the BRCONFIG remote console program and
save the changes, then start the Novell PCONSOLE utility.
8 If you have NetWare 4.xx, change the mode to Bindery Mode by
pressing the F4 key. Select print server Information (NetWare
3.xx) or print servers (NetWare 4.1x; ignore the warning
message) from the Available Options menu.
9 You will be shown a list of current print servers. Press the
INSERT key to create a new entry, type in the NetWare print
server name (
BRN_xxxxxx_P1 by default, where xxxxxx is the
last six digits of the Ethernet address) and press ENTER.
Return to the main Available Options menu by pressing
ESCAPE.
10 Select the Print Queue Information (NetWare 3.xx) or Print
Queues (NetWare 4.1x) menu option to see list of configured
print queues.