English – Philips HAIRCLIPPER Series 1000 Cortapelos User Manual

Page 2

Advertising
background image

ENGLISH

General description (Fig. 1)

A

Cutting element

B

On/off switch

C

Mains cord with adapter

D

Hair clipping comb attachment

E

Adjustment button

F

Cleaning brush

G

Hairdresser’s comb

H

Hair chamber

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Danger

Make sure the adapter does not get wet.

Warning

Check if the voltage indicated on the adapter and on

the appliance corresponds to the local mains voltage

before you connect the appliance.

The adapter contains a transformer. Do not cut

off the adapter to replace it with another plug, as

this causes a hazardous situation.

This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

Children should be supervised to ensure that they

do not play with the appliance.

Caution

Do not use the appliance in the bath or in the

shower.

Use and store the appliance at a temperature

between 15°C and 35°C.

If the adapter is damaged, always have it replaced

with one of the original type in order to avoid a

hazard.

Do not use the appliance when the clipping

attachment or one of the combs is damaged or

broken as this may cause injury.

This appliance is only intended for clipping human

scalp hair. Do not use it for any other purpose.

If the appliance is subjected to a major change in

temperature, pressure or humidity, let the appliance

acclimatise for 30 minutes before you use it.

Compliance with standards

This Philips appliance complies with all standards

regarding electromagnetic fields (EMF). If handled

properly and according to the instructions in this user

manual, the appliance is safe to use based on scientific

evidence available today.

Using the appliance
Clipping with the hair clipping comb

attachment

Note: Make sure your hair is clean and dry. Do not use the

appliance on freshly washed hair.

1

Comb your hair with a styling comb in the

direction of hair growth. (Fig. 2)

2

Slide the comb attachment into the guiding grooves

of the appliance (‘click’). (Fig. 3)

Make sure that the comb attachment has been properly

slid into the grooves on both sides.

3

To set the comb attachment to the desired hair

length, press the adjustment button (1) and slide

the comb attachment to the desired hair length

setting (2). (Fig. 4)

Hair length settings

With the hair clipping comb attachment attached, the

appliance has 7 different hair length settings:

Hair length setting

Resulting hair length

1

3mm

2

6mm

3

9mm

-

-

-

-

-

-

-

-

-

-

-

Hair length setting

Resulting hair length

4

12mm

5

15mm

6

18mm

7

21mm

4

Put the adapter in the wall socket.

5

Wait a few seconds and then slide the on/off switch

to the ‘on’ position.

6

Move the appliance through the hair slowly.

Tips:

Start to clip at the highest setting of the comb

attachment and reduce the hair length setting

gradually.

Write down the hair length settings you selected to

create a certain hairstyle as a reminder for future

clipping sessions.

To clip in the most effective way, move the appliance

against the direction of hair growth. (Fig. 5)

Try different directions (upward, downward or

across), because hair doesn’t all grow in the same

direction.

Make overlapping passes over the head to ensure

that the appliance catches all the hairs that need to

be cut.

Make sure that the flat part of the hair clipping comb

attachment is fully in contact with the scalp to obtain

an even cutting result.

To achieve a good result with curly, sparse or long

hair, you can use a comb to guide the hair towards

the appliance.

Regularly remove cut hair from the comb

attachment. If a lot of hair has accumulated in

the comb attachment, remove it from the appliance

and blow and/or shake the hair out of it.
Contouring without hair clipping comb

attachment

You can use the appliance without comb attachment

to cut your hair very close to the skin (0.8mm) or to

contour the neckline and the area around the ears.

Note: When you use the appliance without comb

attachment, it cuts the hair very close to the skin.

1

To remove the comb attachment, press the

adjustment button (1) and pull the comb

attachment off the appliance (2). (Fig. 6)

2

Before you start to contour the hairline round the

ears, comb the hair ends over the ears.

3

Tilt the appliance in such a way that only one

edge of the cutting element touches the hair

ends. (Fig. 7)

4

Only cut the hair ends. The hairline has to be close

to the ear.

5

To contour the neckline and sideburns, turn the

appliance and make downward strokes. (Fig. 8)

6

Move the appliance slowly and smoothly. Follow the

natural hairline.
Cleaning

Do not use abrasives, scourers, compressed air or

liquids such as alcohol, petrol or acetone to clean the

appliance.
Only clean the appliance and the adapter with the brush

supplied.
Do not use any sharp objects to clean the appliance.
Clean the appliance after every use.

1

Make sure the appliance is switched off and

disconnected from the mains before you clean it.

2

To remove the comb attachment, press the

adjustment button (1) and pull the comb

attachment off the appliance (2). (Fig. 6)

3

Clean the cutting element and the hair chamber

behind the cutting element with the brush

supplied (Fig. 9).

-

-

-

-

-

-

-

-

Note: The cutting element cannot be detached and the

appliance cannot be opened.

The appliance does not need any lubrication.

Replacement

The mains cord and adapter of this appliance cannot be

replaced. If the mains cord or the adapter is damaged, the

appliance must be discarded.

Only the hair trimming comb attachment is replaceable.

Environment
Do not throw away the appliance with the normal

household waste at the end of its life, but hand it in

at an official collection point for recycling. By doing

this, you help to preserve the environment (Fig. 10).
Guarantee and service

If you need service or information or if you have a

problem, please visit the Philips website at

www.philips.com or contact the Philips Consumer Care

Centre in your country (you find its phone number in

the worldwide guarantee leaflet). If there is no Consumer

Care Centre in your country, go to your local Philips

dealer.

-

4203.000.4546.2

2/8

Advertising