Philips ErgoFit Aspirador sin bolsa - Manual (Page 9)

Brush attachment
1 To assemble the brush attachment, slide it onto the bottom of the small nozzle
(‘click’) (Fig. 16).
2 To disassemble the brush attachment, slide it off the bottom of the small nozzle.
tri-active nozzle
1 Use the hard floor setting to clean hard floors (for instance for tiled, parqueted, laminated
and linoleumed flooring): push the rocker switch on top of the nozzle with your foot to
make the brush strip come out of the housing. At the same time, the wheel is lifted to
prevent scratching and to increase manoeuvrability (Fig. 17).
2 Use the carpet setting to clean carpets: push the rocker switch again to make the brush strip
disappear into the nozzle housing. The wheel is lowered automatically (Fig. 18).
remote control operation
- The remote control has three buttons (specific types only) or four buttons (specific types only)
with which you operate the vacuum cleaner.
- The infrared-active light flashes when you press a button on the remote control. (Fig. 19)
using the appliance
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Press the on/off button on top of the appliance to switch on the appliance (Fig. 20).
Tip: To avoid bending your back, press the on/off button with your foot.
, The vacuum cleaner starts operating at the highest suction power level.
3 To switch off the appliance, press the on/off button on top of the appliance or the standby
button on the remote control.
adjusting suction power
1 During vacuuming, you can adjust the suction power level with the – and + buttons on the
remote control.
- Use maximum suction power to vacuum very dirty carpets and hard floors.
- Use minimum suction power to vacuum curtains, tablecloths etc.
pausing during use
1 If you want to pause for a moment, press the standby button on the remote control to
switch off the appliance temporarily.
2 Insert the ridge on the nozzle into the parking slot to park the tube in a convenient
position (Fig. 21).
3 To ensure stable parking of the telescopic tube, adjust the tube to the shortest length.
4 To continue vacuum cleaning, simply press the standby button on the remote control again.
Cleaning the filter cylinder
A clean filter cylinder helps maintain high suction power.
After every vacuuming session, clean the filter cylinder in the way described below.
Always leave the hose connected to the appliance during the filter-cleaning process to prevent
dust from coming out of the appliance.
English 9