Filling the cartridge, Setting the fragrance level, Storage – Philips Jewel Aspirateur avec sac User Manual

Page 9: Replacing/emptying the dustbag, Replacing the disposable dustbag

Advertising
background image

In case of eye contact, flush immediately with plenty of water.

Filling the cartridge

1

Place your thumb and index finger on the sides of the cartridge. Press on the disc (1) and lift

the cartridge out of the holder (2) (Fig. 20).



To remove the cap of the cartridge, apply pressure on the small pressing points (1) and then

pull the cap upwards (2) (Fig. 21).



Open the package at the small opening at the top.



Fill the cartridge with the contents of one whole package of scent granules.

5

Close the cartridge by putting the cap back onto it (‘click’).

6

Re-insert the cartridge into the holder (‘click’). It only fits into the holder in one way

(Fig. 22).

Replace the granules when the cartridge no longer emits any fragrance.

setting the fragrance level
You can set the fragrance level by turning the cartridge forwards (maximum emission) and

backwards (minimum emission) (Fig. 23).

When you store the vacuum cleaner or do not want any fragrance to be emitted, close the

cartridge by turning it backwards until the openings of the cartridge are no longer visible.

storage

1

Switch off the appliance and remove the mains plug from the wall socket.



Press the cord rewind button to rewind the mains cord (Fig. 24).



Put the appliance in upright position. To attach the nozzle to the appliance, insert the ridge on

the nozzle into the storage slot (Fig. 25).



Always put the Tri-Active nozzle in the carpet setting when you store it. Also prevent the side

brushes from becoming bent (Fig. 8).

Replacing/emptying the dustbag

Always unplug the appliance before you replace the disposable dustbag or empty the reusable

dustbag.

replacing the disposable dustbag
Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.

even when the nozzle is not placed on the floor (Fig. 26).

1

Pull the cover upwards to open it (Fig. 27).



Lift the dustbag holder out of the appliance (Fig. 28).

Make sure you hold the dustbag upright when you lift it out of the appliance.



Pull at the cardboard tag to remove the full dustbag from the holder (Fig. 29).

When you do this, the dustbag is sealed automatically.



Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder as

far as possible (Fig. 30).

5

Put the dustbag holder back into the vacuum cleaner (Fig. 31).

Note: If no dustbag has been inserted, you cannot close the cover.

-

-

-

,

English

9

Advertising
This manual is related to the following products: