Philips Brosse multi-styles - Manual (Page 9)

using the appliance
With the Salon Multistylist 10-in-1 you can create tight curls, large curls,
waves, large or small ringlets, oval curls, flicks and a sleek look.
1 Comb or brush your hair so that it is disentangled and smooth.
 Connect an attachment to the handle (see chapter ‘Preparing for
use’). Make sure that the support points downwards.
 Place the appliance on the support of the attachment.
 Put the mains plug in the wall socket.
The power-on light goes on and the appliance heats up (Fig. ).
The appliance is ready for use when the ready dot on the
attachment changes colour (Fig. 5).
5 Style your hair. See the sections below for specific instructions for
each attachment.
Note: When you use one of the curling attachments or the slide-on brush,
always make sure that you wind the end of the lock in the required direction.
6 Leave the styler in your hair for a few seconds.
How long you have to keep the styler in your hair depends on the
thickness of your hair.
Do not leave the styler in your hair longer than 10 seconds.
large or tight curls
1 Connect the large or small curling attachment to the handle.
 Take a lock of hair, press the lever to open the clip and place the
lock between the barrel and the clip (Fig. 6).
 Release the lever and slide the barrel to the end of the lock. Then
wind the lock round the barrel.
Note: Make sure that you wind the end of the lock in the required direction.
 Open the clip after 5 to 10 seconds and remove the barrel from
the hair.
,
,
EnglisH 9