Olympus E-3 Digital - Manual (Page 19)

D I G I T A L T E C H N I C A L S U P P O R T
O L Y M P U S I M A G I N G A M E R I C A I N C .
( 8 8 8 ) 5 5 3 - 4 4 4 8
h t t p : / / s u p p o r t . o l y m p u s a m e r i c a . c o m
©2008 Olympus Imaging America Inc. Page 19 of 26 Last updated on February 28, 2008
Can the E-3 use a flash with shutter sync speeds higher than 1/250th
of a second?
The optional FL-36, FL-36R, FL-50, and FL-50R flash units have a Super FP Flash mode
which enables flash sync at shutter speeds higher than 1/250 th of a second. This is
accomplished by the flash emitting what is essentially a very high-speed stroboscopic
“flicker” flash, rather than a single flash of light. Situations in which this would be
desirable would be fill-flash outdoors in bright sunlight where high shutter speeds would
be needed.
I have E-System flash accessories that I’ve been using with my E-1.
Are these compatible with the E-3?
The E-System flash accessories are fully compatible with the E-3. These include:
• FP-1 Flash Power Grip
• SHV-1 High Voltage Power Pack
• FC-1 Macro Flash Controller
• RF-11 Ring Flash
• TF-22 Twin Flash
Can I use my Olympus FL-40 external flash on the E-3?
The Olympus FL-40 external flash is not compatible with the E-3 because it was not
designed to work with the TTL firmware in the camera.
I have a third-party electronic flash. Can I use it on the E-3?
Flash units that are not part of the Olympus E-System may pose problems if used on the E-3.
Thyristor-type flash units can be used with the E-3’s Manual shooting mode as long as
the sync voltage does not exceed 6 VDC. Third-party TTL flash units will not have TTL
capability because the contact pins in the camera hot shoe probably won’t align with the
contacts on the flash. In addition, the TTL communication with the E-3 may damage the
camera circuitry or corrupt the camera firmware.
Can I use the E-3 with my studio flash equipment?
The E-3 uses an electronic rather than mechanical sync circuit that is rated at 6 VDC
maximum sync voltage. Also, the polarity of the studio flash sync pulse may be opposite
the polarity of the E-3 sync circuitry.
Studio flash equipment should be connected to the E-3 using the Safe Sync Hot Shoe
to PC Sync Adapter. The adapter protects the camera from excessive sync voltage up
to 400 VDC, and automatically corrects sync pulse polarity. This item (#200329) may
be purchased from authorized Olympus dealers and also online directly from The
Olympus Store. To order from the Olympus Store, click here .
How many images can be shot on a single charge of the BLM-1
lithium-ion rechargeable battery?
Although the number of images that can be captured depends upon the shooting
conditions and the camera functions used, a fully charged BLM-1 battery should take
approximately 400 images before it needs to be recharged.