Philips 46HFL3683S-F7 - Manual (Page 7)

7 EN
Channel installation
This section describes how to install the TV channels
automatically.
1
Connect the RF signal to the TV.
2
Plug the power cord into the power outlet.
46HFL3683S / 40HFL3683S
Cable
ANT. IN
32HFL3663S
Cable
3
Turn the TV on.
• Press . POWER at the side of the TV or use the
. (POWER) on the remote control.
46HFL3683S / 40HFL3683S 32HFL3663S
4
Press RC5 SETUP to put the remote control into setup
mode, then press the HOME/MENU button to display
the setup menu. (Hereafter, HOME/MENU will be simply
referred to as MENU)
5
Select [Consumer TV setup] - [Setup] - [Autoprogram];
then select Cable. (unless the installation is using only
Antenna signals - in which case you would select
Antenna)
Note
• The TV will not tune any channel that has not been fi rst “installed”. This
includes SPI direct tune commands!