Philips 40PFL7705D-F7 - Manual (Page 13)

12
Switching channels
Press CHANNEL + / − on the side of the TV.
•
Press CH + / − or enter a number on the remote control.
For digital channels, press a number (1 to 999) followed by a dot
“•” and then the corresponding sub channel number (1 to 999).
e.g. 108.30.
• Press PREV. CH to return to the previously viewed channel.
5 Use your TV
This section helps you perform basic TV operations.
Switching on your TV and putting it in
standby mode
To switch on
• Press
.POWER at the side of the TV or press .(standby-On)
on the remote control.
To switch to standby
• Press
.POWER at the side of the TV or press .(standby-On)
on the remote control again.
Note
• Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
EN