JLG M400 Operator Manual - Manual (Page 102)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-20 – JLG Lift – 3121644
2. Tighten nuts in the following sequence:
3. The tightening of the nuts should be done in stages. Follow-
ing the recommended sequence, tighten nuts per wheel
torque chart.
4. Wheel nuts should be torqued after first 50 hours of opera-
tion and after each wheel removal. Check torque every 3
months or 150 hours of operation.
6.6 SUPPLEMENTAL INFORMATION
The following information is provided in accordance with the
requirements of the European Machinery Directive 2006/42/EC
and is only applicable to CE machines.
For electric powered machines, the equivalent continuous A-
Weighted sound pressure level at the work platform is less than
70dB(A)
For combustion engine powered machines, guaranteed Sound
Power Level (LWA) per European Directive 2000/14/EC (Noise
Emission in the Environment by Equipment for Use Outdoors)
based on test methods in accordance with Annex III, Part B,
Method 1 and 0 of the directive, is 104 dB.
The vibration total value to which the hand-arm system is sub-
jected does not exceed 2,5 m/s 2 . The highest root mean square
value of weighted acceleration to which the whole body is sub-
jected does not exceed 0,5 m/s 2 .
Table 6-11. Wheel Torque Chart
TORQUE SEQUENCE
1st Stage 2nd Stage 3rd Stage
40 ft. lbs.
(55 Nm)
100 ft. lbs.
(130 Nm)
170 ft. lbs.
(255 Nm)