JLG 1200SJP Operator Manual - Manual (Page 32)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-4 – JLG Lift – 3121141
Pre-Start Inspection
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage (oil, fuel, or bat-
tery fluid) or foreign objects. Report any leakage to the
proper maintenance personnel.
2. Structure - Inspect the machine structure for dents, dam-
age, weld or parent metal cracks or other discrepancies.
3. Decals and Placards – Check all for cleanliness and legibil-
ity. Make sure none of the decals and placards are missing.
Make sure all illegible decals and placards are cleaned or
replaced.
4. Operators and Safety Manuals – Make sure a copy of the
Operator and Safety Manual, EMI Safety Manual (Domestic
only), and ANSI Manual of Responsibilities (Domestic only) is
enclosed in the weather resistant storage container.
5. “Walk-Around” Inspection – Refer to Figure 2-2. and Figure
2-3.
6. Battery – Charge as required.
7. Fuel (Combustion Engine Powered Machines) – Add the
proper fuel as necessary.
8. Engine Oil Supply - Ensure the engine oil level is at the Full
mark on the dipstick and the filler cap is secure.
9. Hydraulic Oil – Check the hydraulic oil level. Ensure hydrau-
lic oil is added as required.
10. Accessories/Attachments - Reference the Operator and
Safety Manual of each attachment or accessory installed
upon the machine for specific inspection, operation, and
maintenance instructions.
11. Function Check – Once the “Walk-Around” Inspection is
complete, perform a functional check of all systems in an
area free of overhead and ground level obstructions. Refer to
Section 4 for more specific operating instructions.
12. Boom Control System Check - Perform a check of the
boom control system as specified in this section.
Parent Metal Crack Weld Crack