JLG 1200SJP Operator Manual - Manual (Page 62)

SECTION 4 - MACHINE OPERATION
4-2 – JLG Lift – 3121141
Controlled Arc
When the Boom Control Select switch is in the automatic mode,
the boom control system automatically controls lift and tele-
scope when the lift function is selected to move the platform
through a predetermined arc, equivalent to the percentage of
extension. (i.e. If you start at 70% boom extension, you will end
up at approximately 70% boom extension no matter where you
stop in the arc). This means that when lifting down, telescope in
will function automatically, or when lifting up, telescope out will
function automatically.
When the Boom Control Switch is in the manual mode, lift and
telescope functions are independent functions controlled by the
operator.