JLG 1200SJP Operator Manual - Manual (Page 72)

SECTION 4 - MACHINE OPERATION
4-12 – JLG Lift – 3121141
Swinging the Boom
To swing boom, use Swing control to select Right or Left direc-
tion.
WHEN SWINGING THE BOOM MAKE SURE THERE IS AMPLE ROOM FOR THE BOOM TO
CLEAR SURROUNDING WALLS, PARTITIONS AND EQUIPMENT.
Raising and Lowering the Boom
NOTE: The lift function is not operable above 15 degrees above horizon-
tal if the axles are not fully extended.
To raise or lower the Boom, use Boom Lift control to select Up or
Down movement.
Telescoping the Boom
NOTE: The telescope function is not operable beyond the transport
position if the axles are not fully extended.
To extend or retract the main boom, use the Telescope Control
Switch to select In or Out movement.
Swinging the Jib
NOTE: For 1000 lb. (454 kg for ANSI markets and 450 kg for CE and Aus-
tralia markets) mode operation, the jib must be centered and the
Jib Swing function is not operable. If the jib is out of the centered
position when in this mode, the jib swing function will allow the
operator to center the jib again.
To swing the jib, use the Jib Swing control to select Right or Left
direction.
4.10 FUNCTION SPEED CONTROL
This control affects the speed of all boom functions and Platform
Rotate. When in the CCW maximum position, Drive is placed in
creep speed.