JLG 4009 Suspended Load Supplement Operator Manual - Manual (Page 27)

Section 2 - Load Management Indicator System (LMIS)
2-5 31200487
Attachment Selection
The machine can operate with various attachments, but the appropriate capacity
chart must be selected by the operator. When an attachment is changed, the LMIS
must be manually set to the corresponding attachment capacity chart.
1. Escape out of all menus.
2. Press the UP button.
3. Press the UP or DOWN button until the part number of the attachment capacity
chart being used is displayed (1).
Note: DO NOT install suspended load type attachments that do not have correct
capacity charts available on the LMIS.
4. Confirm the selection by pressing the ENT button.
5. The correct attachment icon (2) should now be displayed.
Note: Before lifting a load, check that the correct operating mode (3) is displayed.
The system should automatically select the correct operating mode.
WARNING
Never use a suspended load type attachment without the appropriate JLG
supplied capacity chart installed on the LMIS. Failure to use the proper JLG
supplied capacity chart could cause a tip over resulting in death or serious injury.
OZ3190
0.0
0.0
0.0
m
0.0
m
0.0
d
0.0
m
0
XXXXXXXXXXA
XXXX XXXX
t
t
max
1
2
3