JLG 266 LoPro Service Manual - Manual (Page 118)

Electrical System
9.26 266, 307 & 266 LoPro
9.13 TROUBLESHOOTING
9.13.1 Analyzer Usage
Help messages can be viewed using the JLG Analyzer
(P/N 2901443). The Help messages can be accessed by
pressing the ENTER key while viewing the current Help
message. The Help message shall be EVERYTHING OK
when no fault is present. The Analyzer cable plugs into
the X26 connector of the PCB board located behind the
operator’s seat.
When the analyzer is first connected, it defaults to access
level 2. Settings may only be viewed in level 2. Settings
cannot be changed until a password is entered to
advance to one of three lower levels.
For more information, contact your local JLG distributor.