JLG 4017 Eccupped for Platform Operator Manual - Manual (Page 45)

Section 2 - Pre-Operation and Controls
2-21 31200028
Anti Theft Device
The anti theft device requires entering a numeric code for operation to prevent
unauthorized use.
Button Values
Changing the Anti Theft Code
The anti theft device is set to a numeric code of 0000 when delivered from the
factory. To prevent unauthorized access change the code upon first use.
1. Turn on the ignition key and wait for the LEDs to go out.
2. Press the OK button for 2 seconds to access the user interface.
3. Using the arrow buttons, move to and select the Anti Theft Device menu item.
Select modify code.
4. Enter the old code. (e.g. 0000) and within 30 seconds enter the new code (e.g.
7777). Confirm with the OK button.
Note: Memorize the new code. Without the access code, the assistance of JLG
Customer Service will be required to start the telehandler.
Activating/Deactivating the Anti Theft Device
1. Turn on the ignition key and wait for the LEDs to go out.
2. Press the OK button for 2 seconds to access the user interface.
3. Using the arrow buttons, move to and select Vehicle Data.
4. Select Display
5. Select Configuration.
6. Use the arrow keys to select Anti Theft Device. Activate or deactivate the anti
theft device as desired. Confirm selection with the OK button.
7. Exit menu by holding the OK key.
OZ0350
C OK
!
1
2
3
4 5 6 7
8
9
0