JLG 4394RT Service Manual - Manual (Page 189)

SECTION 6 - GENERAL ELECTRICAL INFORMATION & SCHEMATICS
3121133 – JLG Sizzor – 6-11
10. Push contact straight into connector grommet until a positive stop is felt. A slight tug will confirm that it is properly
locked in place.
Figure 6-15. HD/HDP Locking Contacts Into Position
NOTE: For unused wire cavities, insert sealing plugs for full environmental sealing
HD30/HDP20 Series Disassembly
Figure 6-16. HD/HDP Contact Removal
11. With rear insert toward you, snap appropriate size extractor tool over the wire of contact to be removed.
12. Slide tool along into the insert cavity until it engages contact and resistance is felt.
13. Pull contact-wire assembly out of connector.
Figure 6-17. HD/HDP Unlocking Contacts
NOTE: Do Not twist or insert tool at an angle.