JLG G12-55A Parts Manual - Manual (Page 32)

BOOM
G10-55A, G12-55A 31200728 2-8
Figure 2-3 Second Boom Section
PAL6371
2
52
61
62
78
85
106
201
103
63
60
55
78 107
114
201
103
90
113
201
67
64
56
84
201
58
105
201
45
86
96
201
6
201
90
201
103
53
60
2
89
63
82
84
201
103
44
63
60
51
54
65
66
47
83
86
139
201
104
201
91
78
83
G10-55A
Note: Wear Pad Shimming:
Whenever a shim is used with a pad, a spacer with
holes must be inserted between pad & shim.
The wear pad or wear pad insert must not sit directly on the slotted surface of shims.
Add wear pad shims & spacers as required to shim boom to maintain a total minimum gap of 0.070 to 0.130 in (1,8 to 3,3 mm) in
both horizontal & vertical directions.
Wear pad bolts require one hardened washer. However, up to (2) hardened washers may be used except where noted otherwise.
Under no circumstances should more than (2) hardened washers ever be used.
The length of pad bolts depends on the number of the shims used. The bolt cannot extend past chamfer on wear pad.
Add Mystik Tetrimoly Grease (14404793) to all wear pads & all wear pad slide pathways. If applicable, this includes all pad grease