JLG G12-55A Parts Manual - Manual (Page 36)

BOOM
G10-55A, G12-55A 31200728 2-12
Figure 2-4 Third Boom Section
PAL6390
54
65
66
3
45
57
201
83
78
68
201
45
57
201
78
58
101
201
45
57
86
102
201
83
62
65
54
69
82
201
78
85
201
103
66
60
55
117
116
201 83
96
100
201
3
48
66
65
54
69
82
84
201
103
63
60
53
6
201
90
93
201
83
83
89
44
63
60
51
50
7
88
88
119
201
119
201
125
201
126
126
G10-55A
Note: Wear Pad Shimming:
Whenever a shim is used with a pad, a spacer with holes must be inserted between pad & shim.
The wear pad or wear pad insert must not sit directly on the slotted surface of shims.
Add wear pad shims & spacers as required to shim boom to maintain a total minimum gap of 0.070 to 0.130 in (1,8 to 3,3 mm) in
both horizontal & vertical directions.
Wear pad bolts require one hardened washer. However, up to (2) hardened washers may be used except where noted otherwise.
Under no circumstances should more than (2) hardened washers ever be used.
The length of pad bolts depends on the number of the shims used. The bolt cannot extend past chamfer on wear pad.
Add Mystik Tetrimoly Grease (14404793) to all wear pads & all wear pad slide pathways. If applicable, this includes all pad grease
fittings at the rear of boom.