JLG 2658E3 Operator Manual - Manual (Page 62)

SECTION 4 - MACHINE OPERATION
4-6 – JLG Sizzor – 3120877
Lifting
If it becomes necessary to lift the machine, it is possible to
lift the machine with a forklift. On all models forklift pock-
ets are provided at the rear of the machine.
In addition, all models can be lifted from either side with a
forklift, provided the forks are placed at the positions indi-
cated by the decals on the machine. It is very important
that the forklift operator use only the designated lifting
areas to lift the machine.
Machines may be equipped with optional bolt-on lifting
lugs, which are attached to the four corners of the frame.
These lugs enable the machine to be lifted using cranes
or other suitable lifting devices.
NOTE: If lifting becomes necessary, from the optional bolt
on lifting lugs, JLG Industries Inc. recommends the
use of a proper spreader bar to avoid damage to the
machine.
NOTE: Forklifts, cranes, or other lifting devices must be
capable of handling the following weights: 1532E3 -
1,315 kg; 1932E3 - 1,383 kg; 2033E3 - 2,032 kg;
2046E3 - 1,878 kg; 2646E3 - 2,073kg; 2658E3 -
2,236 kg.
4.12 TOWING
It is not recommended that this machine be towed, except
in the event of an emergency such as a machine malfunc-
tion or a total machine power failure. Refer to Section 6 for
emergency towing procedures.
Figure 4-3. Lifting Chart