JLG 4017PS Platforms Operator Manual - Manual (Page 49)

Section 7 - Lubrication and Maintenance
7-1 31200345
SECTION 7 - LUBRICATION AND MAINTENANCE
7.1 INTRODUCTION
Service the product in accordance with the Operation & Safety Manual supplied with
telehandler and the maintenance schedule on the following pages.
Clothing and Safety Gear
• Wear all the protective clothing and personal safety devices issued to you or
called for by job conditions.
• DO NOT wear loose clothing or jewelry that can get caught on controls or moving
parts.
7.2 GENERAL MAINTENANCE INSTRUCTIONS
Prior to performing any service or maintenance on the telehandler, follow the
shut-down procedure on page 4-3 unless otherwise instructed. Ensure
telehandler is level, for proper fluid readings.
• Clean lubrication fittings before lubricating.
• Apply a light coating of engine oil to all linkage pivot points.
• Intervals shown are for normal usage and conditions. Adjust intervals for
abnormal usage and conditions.
WARNING
CUT/CRUSH/BURN HAZARD. Do not perform service or maintenance on the
machine with the engine running, with the exception of the transmission oil level
check.