Echo PE-225 Serial S78712051201 - S7871212999999 - Manual (Page 13)

PE-225 ASSEMBLY
X7722272308 13
© 2/2014 ECHO Inc.
ASSEMBLY
Drive Shaft/Power Head
1. Stand engine on a level surface.
2. Remove vinyl cap from drive shaft.
3. Loosen the two bolts (A) at drive shaft end of engine.
4. Carefully fit drive shaft assembly to engine, making sure that
inner drive shaft engages into clutch mount.
Note: Rotate the drive shaft housing until edger housing is in
line with the engine.
5. Tighten bolts (A).
Throttle Linkage and Ignition Leads
1. Close choke and remove air filter cover.
2. Place throttle linkage (A) into adjustment fixture (B) and
install wire end into large carburetor throttle swivel hole (C).
Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. The
throttle linkage must be adjusted by moving the adjustment
nut (D). Consult with your Echo Dealer for correct
adjustment procedure.
3. Tighten nut (E).
4. Connect 2 ignition stop leads (F, G) from throttle cable
tubing to 2 ignition leads (F, G) on engine.
Parts Required: Power Head, Drive Shaft Assembly
I A
A
B
C D
E
F
G
H