Danuser 9000 Postmaster/SlabBlaster - Manual (Page 11)

11
After the post is in position, the second person must move
away from the Postmaster and vehicle.
Operation
Postmaster
STEP 17: After setting the flow control, turn off the auxiliary hydraulics. Slide the hammer
back into the Postmaster/Slab Blaster.
STEP 18: Slowly tilt the Postmaster/Slab Blaster back to a vertical position.
STEP 19: Shut off the vehicle, and disconnect the hydraulic hoses. Route the hydraulic
hoses through the quick attach plate hose holder, and reconnect the hydraulic
hoses to the vehicle auxiliary hydraulics.
If you have purchased a Postmaster with Grapple, we recommend you use your Postmaster
without the Grapple a few times before installing the Grapple.
STEP 1: Without the Grapple, the Postmaster requires a second person to position the post.
This person will set the post at the desired location and grasp the post securely,
making sure his hands are at least 30 inches from the top of the post.
STEP 2: After the post is in position, move the vehicle with the arms raised and position the
Postmaster directly over the top of the post.
STEP 3: Lower the Postmaster onto the top of the post, ensuring the post is inside of the
positioning collar. Continue lowering until the collar and head assembly have
moved up approximately 2 inches. Gauge this measurement by watching the post
guide on the back of the attachment, visible from the vehicle operator’s seat.
Do not operate the Postmaster/Slab Blaster with the transit
bolt installed.
C A U T I O N
Assembly &
Installation
(continued)
D A N G E R
Before you operate the attachment, check over pins and
connections to be sure they all are securely in place. Make
sure the Postmaster/Slab Blaster is securely latched to the
vehicle.
D A N G E R
when using a second person, do not turn on the auxiliary
hydraulics until the second person is clear from the work
area.
D A N G E R
The Postmaster is
designed to be operated
from the vehicle seat.
Keep bystanders away
from the work area. Do
not operate with another
person in contact with any
part of the Postmaster.
D A N G E R D A N G E R
Consult local utility companies to make certain there are
no buried gas lines, electrical cables, etc., in the work
area before beginning operation. Do not drive posts near
underground utility lines.
Stay away from power
lines when transporting,
raising, or operating the
attachment.
D A N G E R