INFICON CI-100 Crucible Indexer - Manual (Page 18)

2 - 2
IP
N 07
4-
54
4-
P1
B
CI-100 Crucible Indexer Operating Manual
Thread the two 10-32 shoulder screws from the inside of one of the box sides until
the threads extend fully to the outside.
Attach the Extender Kit to the CI-100 controller by threading the shoulder screws
into the matching holes in the instrument covers.
Attach the rack mounting ears with the 10-32 flat-head screws provided.
Mount the assembly in a 19 in. rack with 10-32 screws (not provided).
2.2.2 Half Rack Adapter
Attach one rack mount ear to the CI-100 with the 10-32 flat-head screws provided.
Attach the adapter plate with 10-32 flat-head screws to the other side of the CI-100.
Mount the second instrument’s rack mount ear to the CI-100 adapter plate with
10-32 rack screws (not provided).
Mount the assembly in a 19 in. rack with 10-32 rack screws (not provided).
2.3 Mounting the Motor
A bracket and coupling is included to assist in mounting the motor drive to most
1 in. Bolt or 2 ¾ in. Conflat rotary feedthroughs with a 0.25 in. drive shaft.
2.3.1 Drive Mount with Bracket
Attach the mounting bracket to the feedthrough, rotating the bracket into the proper
orientation for your vacuum system. Loosen the flexible coupling set screws and
slide the coupling onto the feedthrough shaft.
Figure 2-2 Motor Drive Mounting
Slide the motor into the mounting bracket until the flexible coupling mates with the
motor shaft.