INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 62)

2 - 42
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
2.3.3.5.12 Materials
Click Edit >> Materials to display the Materials window where the Density and
Z-Ratio values can be edited and saved, and the name of the material can be
edited and saved. See
Figure 2-33 .
Figure 2-33 Materials window
Material . . . . . . . . . . . . . . . . Select a Material from the Material library list to
display the Density and Z-Ratio for that material. The
Density and Z-Ratio values can be edited and the
new values can be saved under the existing Material
name. An existing Material name can be renamed or
a new Material name can be created.
Rename . . . . . . . . . . . . . . . Displays the Rename Material Name window where
the currently displayed name can be changed and
saved to the Material library (the original name is
removed from the library).
NOTE: If the renamed material is used by a Film,
the material name displayed in the
Source/Sensor tab of the Film Edit window
will automatically change to the new name.
Figure 2-34 Rename Material Name window