MTS Series 505G2 SilentFlo Hydraulic Power Unit Model 505G2-180 - Manual (Page 40)

Note:
If a controller is not used, the installed jumper plug must be used or the unit will not start.
HPU Setup
The following procedure should only be performed at HPU installation to verify settings, when you replace
the user interface panel, or if you need to change a selection.
1. Rotate the power disconnect switch to the on (|) position.
2. On the user interface Main Display, select the language.
3. On the user interface Main screen ensure that the Remote Operation button is not selected (gray), indicating
the HPU is in local mode.
4. On the user interface panel, press the Setup button display the HPU Setup screen.
40 Series 505G2 SilentFlo™ Hydraulic Power Unit Product Information
Installation