Schroth Racing QuickFit And QuickFit Pro BMW E36 & E46 3 Series - Manual (Page 13)

• One indication that the belt was exposed to excess strain
and therefore requires replacement is when the stitches of
the asm-system are ripped open and are protruding from
underneath the asm-plastic cover.
A restitched asm seam is dangerous.
The asm energy conversion device may not be restitched
under any circumstances.
13
After an accident, in addition to replacing seat belt which were
in use, also be sure to ask your car dealer for carefully check all
seatbelt attachment points for deformation or cracks. Always
make sure that the guidelines of the car manufacturer are
followed if a repair is necessary.
3
Re-assembling the length adjuster
We do not recommend to disassemble the length adjuster
during installation process. Even to run the harness belt
through the openings at racing seats disassembling is
not necessary.
If for any reason the length adjuster is disassembled, strictly
follow the procedure step by step as described below to re-
assemble the adjuster.
4 Cleaning
To clean the belt, use soap and warm water. Do not use any
solvents! Do not dry the belt in the sun or near a radiator.
Improper cleaning or drying of the harness belts can
weaken them, reduce their effectiveness and can result in
serious personal injury or death.
5 Installation Accessories
Color key:
black=0, blue=1, red=2, yellow=3, purple=5, green=8
The X in PINs must be substituted by the color key of the color you want to order!
Shoulder belt pads, pair of black with yellow flock printing 00109
Shoulder belt pads, pair of blue with black flock printing 01109
red, yellow, purple, green with black flock printing 0X109
Shoulder belt pads, pair of black with grey flock printing 09109
Shoulder belt pads, pair of silvergrey w. black flock printing 09209
Shoulder belt pads, pair of black with black flock printing 09309
Adjusting grips for length adjuster, 4 pcs./package 00092
6 Spare Parts
If any part of your harness needs replacement, please contact
your nearest dealer. USE ONLY GENUINE SCHROTH PARTS.
Cover for adjuster inclusive retainer
01084
-------------------------------------------------------------------------------------
-
We reserve the right to incorporate any technical
changes or further development in this product
without notice.
If you need additional information or have any comments
or questions about the SCHROTH asm harnessbelts,
please contact your dealer or the importer.
www.schrothracing.com
To locate you nearest dealer call:
(800) 884-BELT
REMEMBER:
For safety’s sake, always buckle up.
SCHROTH and SCHROTH-asm ® are registered trademarks of
SCHROTH Safety Products GmbH, Germany.
The SCHROTH-asm
® safety system is patented in several European
countries, the United States and Japan.
The copyrights of this Installation and Operating manual are
property of SCHROTH Safety Products GmbH, Germany.
Copyright of this part or in hole, on paper, on film or electronically
is allowed only after written permission by SCHROTH Safety
Products GmbH, Germany.
© 2002, SCHROTH Safety Products GmbH, Arnsberg, Germany.