Rockwell Automation 1784-PM02AE PCI 2 Axis Servo Card - Manual (Page 9)

PCI 2 Axis Servo Card 9
Publication 1784-IN005B-EN-P- July 2002
Access the Computer’s PCI Local Bus Expansion Slots
To install the card, you must access the computer’s PCI local bus
expansion slots. Follow these general steps, or refer to your
computer’s user guide for instructions on how to:
1. Turn off the power to the host computer with the power
switch.
2. Remove the computer’s cover.
3. Select a vacant PCI local bus expansion slot. Make sure the
vacant slot is on the main PCI Bus.
4. Remove the slot’s expansion cover. Remove the screw on the
back (rear bracket) of the computer.
Insert the Card
To insert the card inside the computer:
1. Follow the card handling instructions on page 6.
2. Push the card’s PCI connection into the PCI Bus.
If you have additional cards to install, repeat steps 1 and 2 for each
card. After the cards (up to four) are installed, use the Sync cable
(1784-PMCSY4) to connect all of the cards.
3. Replace and tighten the expansion slot screw.
4. Turn on the computer to make sure it comes up correctly.
If the computer then:
powers up go to step 5.