Remove the support pan – Rockwell Automation 2100 CENTERLINE Low Voltage Motor Control Centers User Manual
Page 59
Advertising
Rockwell Automation Publication 2100-IN012E-EN-P - February 2012
59
Installing and Removing Plug-in Units Chapter 4
Remove the Support Pan
1.
For ArcShield sections with 100 ms arc duration rating, remove the vertical
wireway baffle and set aside for installation later.
2.
Pry the plastic retaining clip from the right-hand unit support by using a
screwdriver.
This is visible in the vertical wireway.
For CENTERLINE MCC units with arc resistant latches, the unit
support pan is secured to the right-hand unit support by the screw that
retains the arc latch bracket. In order to remove the unit support pan, you
must remove the arc latch bracket.
Plastic
Retaining
Clip
Arc Latch
Bracket
Advertising